Imagine Selenio X100, Инструкция по установке и эксплуатации

Страница: 98 / 178

Selenio X100
Installation and Operation Manual
86
Audio Bit Manipulation
This section contains information on the manipulation of bits that occur when using the
Selenio X100 modules.
RX Key : N = not recognized, Y = recognized, S = recognized and stored or passed through
or both
TX Key : N = not transmitted, Y = transmitted
Channel Status Bits
Table 3-11 C-Bit Manipulation
Byte Bit Function RX TX Remarks
0 0 [0] Consumer use
[1] Professional use N
Y N
Y Set to [1]
0 1 [0] Normal Audio Mode (linear PCM)
[1] Non-audio (non-PCM) S
S Y
Y Passed unmodified
0 2 to 4 [000] Not indicated
[100] No emphasis
[110] 50/15 µs
[111] CCITT J.17 S
S
S
S Y
Y
Y
Y Passed unmodified
0 5 [0] Locked
[1] Unlocked N
N Y
N Set to [0]
0 6 to 7 [00] Not indicated
[01] 48 kHz
[10] 44.1 kHz
[11] 32 kHz Y
Y
Y
Y N
Y
N
N Set to [01]
1 0 to 3 [0000] Not indicated
[0001] Two channel
[0010] Mono
[0011] Prim/sec
[0100] Stereo
[0101] to [1111] Undefined N
N
N
N
N
N Y
N
N
N
N
N Set to [0000]
1 4 to 7 [0000] Not indicated
[0001] 192 bit block
[0010] AES18 (HDLC)
[0011] User defined
[0100] to [1111] Undefined N
N
N
N
N Y
Y
Y
Y
Y Set to [0000]
2 0 to 2 [000] Not indicated
[001] Audio data
[010] Co-ordination signal
[011] to [111] Undefined N
N
N
N N
Y
N
N Set to [001]
2 3 to 5 [000] Not indicated
[001] Max length - 1
[010] Max length - 2
[011] Max length - 3
[100] Max length - 4
[101] Max length
[110] to [111] Undefined N
N
N
N
N
N
N N
N
N
N
N
Y
N Set to [101]