Imagine Selenio X100, Инструкция по установке и эксплуатации

Страница: 68 / 178

Selenio X100
Installation and Operation Manual
56
Texture Level and Texture Overshoot
The Texture Level parameter is used in conjunction with the Noise Reduction control to
provide enhancement on small edges.
Texture Overshoot is used in conjunction with the Texture Level to provide
enhancement on small edges.
Noise Adaptation
This parameter sets the noise adaptation threshold for sharpness and texture enhancement.
It controls the noise reduction setting in conjunction with the motion in the video signal, on
a scale of
0 to 1000 .
Film Mode Enable
Use this parameter to enable cadence detection and “film mode” video processing.
Logo Generation and Insertion
The Selenio X100 provides logo generation, static on-screen logo insertion, and animated
on-screen logo insertion.This feature requires an optional 8 GB or 16 GB memory module
(X100OPT-MEMMOD8GB or X100OPT-MEMMOD16GB, respectively); and an
X100OPT-SK-ALG software key license. For dual-channel logo generation and insertion, two
softkeys are required.
The memory module is shared with the X100’s program delay feature. Both the program
delay and the logo generator can be used at the same time. However, the 16 GB memory
makes it possible to use longer animated logos.
Static logos used by the X100 are in the .mg2 file format. Starting from release 2.0, with
additional memory module installed, the X100 provides on-screen animated logo insertion
capability. Animated logos used by the X100 are stored in the VIA 2.0 file format with file
extension.
via .
Logo files must be loaded into the X100 before they can be displayed. There are two
storage locations: the main board (up to 10MB), and the
optional memory module (16 GB).
Main board storage location is used to store files for static logo display only; the memory
module location stores both static and animated logos.
To load a logo file into the system, follow these steps:
1 On the Configuration page, select Logo Management .
2 Click the Upload button to select the file for previewing and uploading.
3 To upload file into the optional memory module, select the MemoryModuleLogos
sub-directory.
4 Click Upload .
When a memory module and its accompanying license keys are installed, additional
animated logo related controls are then enabled.