Imagine Selenio X100, Инструкция по установке и эксплуатации

Страница: 31 / 178

Selenio X100
Installation and Operation Manual
19
Changing the PC Network Settings
In unusual situations, such as correcting a failed software upgrade, you may need to change
your PC network settings. Follow these steps to change the settings:
1 Change the IP Address of the PC to match that of the Selenio X100, by following theses
steps:
a Click Start > Settings and then click Control Panel .
This opens the Control Panel window.
b Double-click Network and Dial-up Connections, and then double-click Local Area
Connection.
c Click the General tab, and then click Properties .
This opens a new Local Area Connection Properties window.
d On the General tab, select Internet Protocol (TCP/IP) , and then click Properties ...,
ensuring you are working on the correct Ethernet adapter for the CCS network.
The IP Address of the Internet Protocol TCP/IP Properties box appears.
Figure 2-9 shows the portion of the Internet Protocol TCP/IP Properties box where you
enter the IP Address, Subnet Mask, and Default Gateway of your PC.
e Note whether Obtain an IP address automatically is selected.
You may need to re-select this option later when you revert back to the original PC IP
Address.
f Select Use the following IP address , and in the IP address box, type a new
computer IP Address to match the first three octets of the IP Address of the Selenio
X100, and then add a different fourth octet.
(For example, if the Selenio X100 IP Address is 192.168.100.50, you could type
192.168.100.181).
g In the Subnet Mask field, type:
255.255.255.0
This value applies to Class C IP addresses; confirm the number with your network
administrator.
h Enter the same Default Gateway number as the one on the Selenio X100, or leave
blank.