Platinum™ IP3
Installation and Operation Manual
Preface
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 16
Safety
This manual contains safety precautions and recommendations specific to the IP3 frame. The IP3 is rack-
mountable using rack rails provided with the unit, and it is strongly recommended to do so. See the
specifications section for the electrical current load of the product, and connect the redundant power
supplies to electrical circuits which are each capable of supplying the full load of the unit. The IP3 is
forced-air cooled; to prevent marring during handling and transit there are clear plastic coatings which
cover the metallic surfaces and obstruct some of the air ventilation holes. Be sure to remove all of these
clear plastic coatings before putting the unit into service.
IMPORTANT!
Only qualified personnel should perform service procedures.
Table 1:
Safety Terms and Symbols in this Manual
WARNING
Statements identifying conditions or practices that may result in
personal injury or loss of life. High voltage is present.
CAUTION
Statements identifying conditions or practices that can result in
damage to the equipment or other property.
Standards
Refer to the
IP3 Safety and Standards Manual
for details.
Waste from Electrical and Electronic
Equipment (WEEE) Compliance
The European Union (EU) Directive 2002/96/EC on Waste from Electrical and Electronic Equipment
(WEEE) deals with the collection, treatment, recovery, and recycling of electrical and electronic waste
products. The objective of the WEEE Directive is to assign the responsibility for the disposal of
associated hazardous waste to either the producers or users of these products. As of August 13, 2005,
the producers or users of these products were required to recycle electrical and electronic equipment at
end of its useful life, and may not dispose of the equipment in landfills or by using other unapproved
methods. (Some EU member states may have different deadlines.)
