4. Start up the mCapture and set up the system
Use the DTP menu to confi gure your mCapture device to
the network.
Connect the mCapture to your local KVM.
Press
CTRL+ALT+F3
to view the third available terminal.
At the login prompt, type
root
and press
Enter.
At the
password
prompt, type
DTVinabox
and press
Enter.
At the
#
prompt, type
stopdtp
and press
Enter.
At the
#
prompt, type
cd/home/
and press
Enter.
At the
#
prompt, type
sh confi guredtp.sh
and press
Enter.
Access the mCapture Confi guration
Menu
Attach an
extension
to the back
of each rail to match the depth of
your rack.
Attach the
rails
to the rack posts.
Slide the chassis into the rail.
To remove the chassis from
the rack:
Stand in front of the unit and pull
the chassis out as far as it will go.
On the
left
side, press down on
the plastic retaining mechanism.
On the
right
side, press up on
the plastic retaining mechanism.
Attach a
slide
to each side of the
chassis using (5) M4x10mm
screws on each side. Make sure
the plastic retaining mechanism
is located at the back of the
chassis.
front rack posts
rear rack posts
slide
rail
2. Rack mount the mCapture
•
1 RU chassis (1)
•
Power cables (2)
Rack rail kit contains the following:
• Rails
(2)
• Slides
(2)
•
Short extensions (2)
•
Nut plates (6)
•
Bag of screws
Cable
•
VHDCI/RJ 16 Port x 6 feet
1. Verify the contents
NX1011MC INSTALLATION
QUICK START
If the customer orders the
NX-ASI-44 card, place the card in
the PCIe x8 bottom slot.
Keyboard (Purple)
Mouse (Green)
RJ-45 IPMI LAN Port
Serial Port
VGA for Video
Integrated RS-422 Control
Ports
Power Supply (2)
USB (2)
Eth0 (NIC 1)
Eth1 (NIC 2)
Optional NX-GE-4
Optional NX-ASI-44
3. Attach the cables to the back panel
Input 0:0
Input 0:1
Input 0:2
Input 0:3
