S
elenio™ Network Processor
User Guide
Introduction
© 2019 Imagine Communications Corp.
Proprietary and Confidential.
May 2019 | Page 20
BNC Ports
BNC ports are divided in groups of four. BNCs are hard-coded so that the first four are assigned to
Processor A Section1, the next four (numbers 5, 6, 7, and 8) are assigned to Processor A Section 2, etc.
Note that the first numbered port in each group is labeled with an inverse square. This port is the 12G
capable port for that group. Ports in each group are numbered in a clockwise fashion. For example, the
left-most port on the chassis is port 2, not port 1.
Pinouts: GPIO/RS232 9-Pin Connector (for future use)
Pin No.
Signal
Comments
1
GND
Signal Ground
9
GPIO4
GPIO Data
5
GND
Signal Ground
3
Tx
Transmitted Data
7
GPIO2
GPIO Data
8
GPIO3
GPIO Data
2
Rx
Received Data
4
GND
Signal Ground
6
GPIO1
GPIO Data
