27
3
Operation
Operating Notes
When you set the control parameters on the SFS6803
+
and OP
+
SFS
+
, observe the
following:
If you make changes to certain parameters, other related parameters may also be
affected. See
Cross-Functional Parameter Changes
on page 42 for more
information.
When you change a parameter, the effect is immediate. However, the module requires
up to 30 seconds to save the latest change. After 30 seconds, the new settings are
saved and will be restored if the module loses power and must be restarted.
Note:
Unless explicitly stated, all references to SFS6803
+
and OP
+
SFS
+
also pertain to
SFS6803
+
BD and OP
+
SFS
+
BD.
Q-SEE Compliant Thumbnails
When installed in an FR6822
+
or FR6802
+
QXF frame that also contains a 6800
+
ETH
resource module, SFS6803
+
and OP
+
SFS
+
module control windows have an extra
Streaming
tab in CCS Pilot and Navigator (version 3.2.1 or later). There you can view
output video from the module.
In addition, video from the SFS6803
+
and OP
+
SFS
+
, displayed at up to three frames per
second, can be displayed on the 6800
+
ETH’s control page, and (for CCS Navigator only) on
Graphical Navigation
pages.
Note:
SFS6803
+
and OP
+
SFS
+
modules all show a SFS6803
+
label in Navigator.
Thumbnail streaming is not supported for the following video standards:
1080i 60
720p 60
1080p 24/25/29.97/30
1080psf 23.98/24
1080p 50/59.94/60
Содержание Selenio 6800 SFS6803+OP+SFS+
