Imagine communications Selenio 6800 SFS6803+OP+SFS+, Инструкция по установке и эксплуатации

Страница: 40 / 118

Chapter 2
Installation
26
2 Lightly wipe the fiber tip in the central portion of the lint-free wipe.
CAUTION: Do not scrub the fiber. Excessive rubbing will leave scratches.
3 Repeat the wiping action on another clean section of the wipe or a new wipe.
4 Inspect the connector again with the fiberscope.
5 If the connection is clean, return to the installation steps on page 22 for back modules, or
page 23 for front modules.
If the connector is still dirty, proceed to the wet cleaning instructions.
Wet Cleaning
Using 99% isopropyl alcohol and lint-free wipes, follow these steps to wet clean the fiber:
1 Fold the wipe into a square, about four to eight layers thick.
2 Moisten one section of the lint-free wipe with one drop of 99% alcohol, ensuring that a
portion of the wipe remains dry.
3 Lightly wipe the fiber end in the alcohol-moistened portion of the lint-free wipe.
4 Immediately repeat the wiping action on the dry section of the wipe, removing any residual
alcohol.
5 Inspect the fiber endface again, and if necessary, repeat the wet cleaning with another
clean section of the lint-free wipe.
CAUTION: Do not scrub the fiber. Excessive rubbing will leave scratches.
6 Dry clean any remaining residue, and then inspect the connector again.
7 If the contamination persists, repeat the dry and wet cleaning procedure until the endface is
clean.
If the fiber end still remains dirty after repeated cleaning attempts, call Customer
Service for further instructions.
If the fiber end is clean, return to the installation instructions on page 22 for back
modules, or page 23 for front modules.
Upgrading
Module
Firmware
This module’s firmware can be updated using CCS Pilot, CoPilot, or Navigator version 3.1.1
or higher, or the HTTP software upgrade tool. In order to perform these upgrades, your
frame must be equipped with a 6800
+
ETH module. See your frame manual for more
information.