Imagine communications Selenio 6800 HUC6800, Инструкция по установке и эксплуатации

Страница: 48 / 84

34 HUC6800
+
Installation and Operation Manual
Chapter 3: Operation
Recalling Default Parameter Settings
Table 3-5 on page 36 describes all of the parameter settings for the
HUC6800
+
and HUC6800
+
C, including the original factory defaults.
To return this module to its default settings, you can either reset each
parameter individually or do a global recall following this procedure:
1. Rotate the hex switch to “0.”
2. Toggle the navigation switch to the bank number “0.”
Use the control LEDs to verify which bank you have selected, or
use an available 6800
+
software control option (serial/local or
Ethernet/remote) to confirm your bank selection.
3. Rotate the hex switch to the global recall parameter “F . ”
4. Toggle the navigation switch to Yes .
Use an available 6800
+
software control option to aid in viewing,
setting, and confirming the parameter value.
On Screen Display (OSD) Monitoring
The HUC6800
+
and HUC6800
+
C modules have two dedicated
HD-SDI outputs that carry the program signal. There are two additional
user-configurable SDI outputs that carry either the same program signal
or an overlaid on-screen display (OSD) monitoring signal. The OSD
can be turned
On or Off by setting the On Screen Display parameter to
the desired option. When in the On position, the output can be used as a
display monitor to view the current parameter selections and controls.
Reading Software and Hardware Versions
You can see the current software and hardware versions of the
HUC6800
+
by checking the Hardware Version and Firmware
Version read-only parameters located at the end of the parameter list
(see page 47 ). These parameters appear in the OSD (see above), and on
CCS-enabled control panels or CCS software applications—such as
Pilot or Navigator.