Imagine communications Selenio 6800 HUC6800, Инструкция по установке и эксплуатации

Страница: 34 / 84

20 HUC6800
+
Installation and Operation Manual
Chapter 2: Installation
7. On the Device tab of the Navigation Properties box, enter the IP
address of the frame that holds the module. (See Figure 2-7 .)
Figure 2-7. Navigation Properties Box
8. In the third field, enter:
1.0.[slotnumber]
(Where, for example, 1.0.5 would refer to the module in slot 5 of
the frame.)
9. Close the window.
10. Double-click the device icon.
The Configuration... box opens. On the File Transfer tab, the
/frame/slot (where x is the slot number) directory appears in the
Select the device directory to transfer to: field.
11. Click Add .
12. In the Add Upgrade Files box, browse, select the module’s
upgrade package and then click OK .
13. Choose the file you wish to upgrade and then click OK .
14. Click Perform Transfer , and then click Yes .
This may take several minutes.
Caution
If you make changes in the last
field (located above and to the
right of the
Set Default button),
you may lose your connection to
the module. If this happens, you
will need to rediscover the
module.
Do not make changes in
this field
Enter frame IP address here
Note
You must delete unwanted files
in the
Add upgrade files for
transfer to device: field before
transferring the files. Otherwise,
the upgrading procedure will
fail.