Error! Use the Home tab to apply Überschrift 1 to the text that you want to appear here.
Image Engineering
Error! Use the Home tab to apply Titel to the text that you want to appear here.
Seite
3
von
11
1 INTRODUCTION
Important information: Read the manual carefully before using this device.
Inappropriate utilization may cause damages to the device, to the DUT (device under test) or other components
of your setup.
Please keep these instructions in a safe place and pass them on to any future user.
1.1 Intended Use
The iQ-LED bundle is provided as a component to build your own spectral programmable light source.
1.2 General Safety Information
WARNING!
Some LEDs are emitting invisible light in the IR and UV near area.
•
Do not
look directly into the emitted light or through the optical LED system.
•
Do not
look directly into the light source when using high intensities or sequences with low
response time.
•
Do not
open the device without any instructions from the Image Engineering support team or
when connected to the power supply.
2 GETTING STARTED
2.1 Scope of Delivery
iQ-LED (V2), CAN-USB adapter board, control panel PCB with ribbon connector cable, USB-cable, Power
supply, a spectrometer with 1M fiber, control software
2.2 Software Installation
Follow SW install instructions from the iQ-LED SW control manual.
If using the iQ-LED C++ API, please follow the installation steps of the iQ-LED API installer and documentation.
