About this Manual
Setup and Assembly Manual
The
Setup and Assembly Manual
is written for
technical staff with some basic
mechanical as well as software skills. Many resellers will offer on-site installation;
therefore, large parts or all of the setup and assembly manual might not be of interest
to the reader. The access level at which the setup and adjustment processes are
performed is called “Power user”. This “Power user” level is password protected to
prevent access by the normal operator.
All information about the normal operation and behavior of this device is found in the
Operation Manual
.
All available manuals for this device can be downloaded from our customer service
portal at
. Be sure to always check for the latest versions
of these manuals.
This manual is divided into four sections, A to D.
Section A
describes the hardware setup. It includes unpacking and mechanical
installation. These instructions must be followed carefully to ensure
proper functionality, best possible quality and performance of the device.
This device is a precision optical instrument and should be handled
accordingly.
Note:
It is recommended to always use the WideTEK 36 in combination with
the floor stand.
Section B
describes the software setup. It includes the optical adjustments
necessary after the setup. The section also describes the option
installation procedure.
Section C
describes cleaning procedures, troubleshooting procedures, and test
scan generation.
Section D
shows all technical data and necessary declarations.
Setup and Assembly Manual
Page 5