Image Access Bookeye Color, Руководство по эксплуатации

Страница: 30 / 72

8.3 Setting new values
To set new values for the displayed parameters, use the following buttons:
—
Use the up / down buttons at the function field TYPE to change the value for AAA as
well as to switch the setting for DHCP between YES and NO.
—
Use the up / down buttons at the function field PAGES to change the BBB value.
—
Use the up / down buttons at the function field COLOR to change the CCC value.
—
Use the up / down buttons at the function field BRIGHTNESS to change the DDD
value.
Press the corresponding button to increase or decrease the desired value.
Press the button continuously to change the values fast upwards or downwards.
8.3.1 Special advice for the gateway address setting
If no gateway is used, use the same address as for the IP address setting.
8.4 Saving new values
Press and hold the START button for at least one second to save the new value.
The display shows the following message.
Settings stored
Please reboot
After this message, the display returns to the serial number.
8.5 Ending the Set-up Mode
To end the set-up mode, press and hold the STOP button for at least three seconds.
The red STOP LED starts blinking.
The display shows the message:
System Shutdown
****************
The lamps and all LEDs on the keyboard will be switched off.
After the power-down sequence is finished, only the green START LED remains on.
Page 30 Operation Manual