illumina 20040482, Руководство по эксплуатации, Страница: 87 / 124

7 - Preventive Maintenance and Repairs
Maintenance Schedule
Infinium LiHa and Infinium RoMa Operating Manual - Document # 1000000110155 v00 7 - 5
7.2 Maintenance Schedule
Note: To ensure a good working condition of the instrument a half-yearly or yearly
(depending on configuration) maintenance carried out by a Illumina authorized
field service engineer (FSE) is recommended.
Maintenance
Record
Note: In order to be able to track all maintenance performed on the Infinium LiHa
and Infinium RoMa over the whole lifetime, the periodic maintenance must be
recorded as follows:
•
Fill in the necessary data in the form “Infinium LiHa and Infinium RoMa Daily/
Weekly Maintenance Checklist”.
• File the form in the “Infinium LiHa and Infinium RoMa Maintenance and
Service Logbook”.
Maintenance
Tables
The maintenance tables are divided according to the frequency the corresponding
maintenance task must be periodically performed. For example, there are tables
for:
 Daily maintenance
 Weekly maintenance
 Half-yearly maintenance
Example and
Explanations
Example for a maintenance table, followed by explanations:
 Instrument/Component
–
Specifies the instrument or one of its individual components on which a
maintenance task must be performed.
 Maintenance Task
–
States briefly what maintenance must be performed on the instrument/
component mentioned before.
 Reference
–
Gives additional information, e.g. on means, tools, etc. that are necessary
to perform the maintenance task mentioned before.
– Contains references to the sections in this manual or to other documents
where the corresponding instructions can be found.
General
Guideline
Note: The daily and weekly maintenance schedule described here is a general
guideline. The schedule and the cleaning agents may have to be adapted to your
special laboratory conditions and depending on your application.
7.2.1 Maintenance: Immediate Maintenance
If the instrument is leaking, switch it off immediately and eliminate the source of
leakage. Refer also to section 7.3.1.1 “Checking for Leaks”,  7-10 .
Tab. 7-4 Example (e.g. daily maintenance)
Instrument/Component Maintenance Task Reference
Part A Clean thoroughly Water with weak detergent
Part B Check adjustment of component C Refer to section X.X.X,  Y-Z