7 - Preventive Maintenance and Repairs
Maintenance Tasks
Infinium LiHa and Infinium RoMa Operating Manual - Document # 1000000110155 v00
7 - 19
7.3.9 Positive Identification (PosID)
WARNING
Fire hazard, if heated parts are cleaned with flammable agents.
Allow the PosID to cool down before cleaning.
ATTENTION
The laser output window of the PosID barcode scanner must be perfectly clean at
all times. Even slight soiling may cause errors.
For cleaning, avoid abrasive substances.
Do not scour the surface. Use a soft, clean tissue.
Barcode
Scanner
To clean the laser output window of the barcode scanner, proceed as follows:
WARNING
Laser light (CLASS 2 LASER PRODUCT).
Do not stare into beam nor into its reflections on the worktable.
Caution – Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Ensure appropriate FDA regulatory actions have been taken for any Class II
laser products.
1
Check if the barcode scanner (A) is in vertical position and if the laser output
window is accessible as shown in the figure below.
If this is not the case, initialize the PosID.
ATTENTION
Damage to the barcode scanner drive if the position of the barcode scanner is
forced manually.
Do not attempt to rotate the barcode scanner manually.
Use the initialization routine to run the barcode scanner into maintenance
position.