ILLKO DIGIOHMPro, Руководство пользователя

Страница: 16 / 18

DIGIOHMpro
- 15 -
For replacing the fuse unscrew two screws and remove the batteries / fuse
compartment cover, see Fig. 2.2. Then remove blown fuse from the fuse holder
(see Fig. 4.1) with a suitable tool (e.g. a small screwdriver) and put in its place
the new fuse. Then put the batteries / fuse compartment cover back and secure
it with two screws. Verify the instrument’s functionality.
4.2. Cleaning
Disconnect both test tips from tested object and turn off the
instrument before cleaning!
Wait until the instrument becomes totally dry before using it!
Use soft cloth, slightly moistened with lukewarm soap water for plastic case
cleaning. Do not spill cleaning liquid over the instrument!
Do not use cleaning liquids based on petrol, hydrocarbons etc.!
4.3. Calibration
Measuring instruments should be regularly calibrated. We recommend interval of
calibration 1 year. Furthermore we recommend carrying out calibration after
each repair. Contact your local distributor for further information.
4.4. Service
Manufacturer, service:
ILLKO, s.r.o.
Masarykova 2226
678 01 Blansko
Czech Republic
tel./fax: +420 516 417 355
e-mail: illko@illko.cz
http://www.illko.cz
Contact your local distributor for further information.
Unauthorized persons are not allowed to open the instrument.
There are no replaceable components inside the instrument, except batteries
and the fuse, refer to the Chapter 4.1.