7
Slide the three O-rings No. 67588 onto the tail boom
. Roughen all the joint surfaces. Run the tail rotor motor power
cables through the tail rotor housing,
then through the tail boom
and finally into the chassis. Push the tail boom into
the tail rotor housing as far as it will go, then apply a drop of cyano to the slot. Glue the boom to the chassis at the
front using the same procedure, but please ensure that the tail rotor shaft is exactly horizontal, i.e. at right-angles to
the main rotor shaft, before applying the cyano. Fix the vertical stabiliser centrally to the underside of the tail boom
and the tailskid using two strips of adhesive tape. Attach the horizontal stabiliser to the tail boom by pushing the two
rear O-rings over the lugs.
The tail boom
180m
m
The CRP tail support (2x175 mm) has to be secured to the side of the chassis with the little clamp and the M2x6 screw.
Now mount the support boom with the large clamp and the additional M2x6 screw to the tail boom. Tighten the screws
carefully, but do not over tighten them!
O-rings
Adhesive tape
Tape
Run the motor leads
through the boom
before gluing!
