68225
5
Please note the different lengths of the skid struts.
67360
67361
68254
68253
3.
3.
1.
1.
3.
3.
2.
2.
First roughen all the joint surfaces with abrasive paper. The
first step is to glue the rear struts 1. into the sockets in the
chassis. Let the glue set hard, then push the front struts 2.
into the chassis from the underside. These struts should rest
squarely against the outside of the vertical part, and must be
parallel to the rear struts. Apply cyano to these joints when
you are confident of the struts' position. Glue the landing
skids 3. to the struts as shown.
The mechanics
Locate the end of the rotor shaft No. 68255 whose
cross-hole is closer to the end of the shaft, and slip the
previously assembled freewheel onto that end. Press
the pin No. 67399 through the holes in the hub and the
shaft using a pair of pliers. Press the two bearings No.
67571 (bottom) and No. 68247 (top) into the housing, slide
the rotor shaft through them and secure the shaft by fitting
the annular clamp No. 68204 on it from the top end. Apply a
drop of cyano to the annular clamp to ensure that it stays in
place when subjected to the negative forces which can arise
in aerobatics.
Glue the swashplate guide extension 68225 in place as
shown. It is important that no glue gets into the guide slot.
68204
67571
68255
68247
76mm
76mm
74mm
74mm
67399
________________________________
4
,5
m
m
