background image

A Consumer Guide to Product Safety

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure 

your personal safety.  However, improper use can result in potential electrical shock or fire 

hazards. Please read all safety and operating instructions carefully before installation and use, 

and keep these instructions handy for future reference. Take special note of all warnings listed 

in these instructions and on the unit.

1.   

Water and Moisture

 – The unit should not be used near water. For example: near a 

bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 

2.   

Ventilation

 – The unit should be situated so that its location or position does not interfere 

with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or 

similar surface that may block ventilation openings.  Also, it should not be placed in a 

built-in installation, such as a bookcase or cabinet, which may impede the flow of air 

through the ventilation openings.

3.   

Heat

 – The unit should be situated away from heat sources such as radiators, heat 

registers, stoves or other appliances (including amplifiers) that produce heat.

4.   

Power Sources

 – The unit should be connected to a power supply only of the type 

described in the operating instructions or as marked on the appliance.

5.   

Power-Cable Protection

 – Power supply cables should be routed so that they are not 

likely to be walked on or pinched by items placed upon or against them.  It is always best 

to have a clear area from where the cable exits the unit to where it is plugged into an AC 

socket.

6.   

Cleaning

 – The unit should be cleaned only as recommended.  See the Maintenance 

section of this manual for cleaning instructions.

7.  

Objects and Liquid Entry

 – Care should be taken so that objects do not fall and liquids 

are not spilled into any openings or vents located on the 

 product.

8.  

Attachments

 – Do not use attachments not recommended by the product manufacturer.

9.  

Lightning and Power Surge Protection

 – Unplug the unit from the wall socket and 

disconnect the antenna or cable system during a lightning storm or when it is left unattended 

and unused for long periods of time. This will prevent damage to the product due to 

lightning and power-line surges.

10. 

Overloading

 – Do not overload wall sockets, extension cords, or integral convenience 

receptacles as this can result in a risk of fire or electric shock.

11. 

Damage Requiring Service

 – The unit should be serviced by qualified service personnel 

when:

 

 A.  the power supply cable or plug has been damaged.

 

 B.  objects have fallen into or liquid has been spilled into the enclosure.

 

 C.  the unit has been exposed to rain.

 

 D.  the unit has been dropped or the enclosure damaged.

 

 E.  the unit exhibits a marked change in performance or does not operate normally.

12. 

Periods of Nonuse

 – If the unit is to be left unused for an extended period of time, such 

as a month or longer, the power cable should be unplugged from the unit to prevent 

damage or  corrosion.

13. 

Servicing

 – The user should not attempt to service the unit beyond those methods 

described in the user’s operating instructions.  Service methods not covered in the 

operating instructions should be referred to qualified service personnel.

Questions? Visit www.ekids.com

eKids, LLC warrants this product to be free from defects in workmanship and materials, under 

normal use and conditions, for a period of one (1) year from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store 

where it was originally purchased. Should this fail to resolve the matter and service still be required 

by reason of any defect or malfunction during the warranty period, eKids will repair or, at its 

discretion, replace this product without charge. This decision is subject to verification of the 

defect or malfunction upon delivery of this product to the Factory Service Center authorized by 

Customer Service. If service is required, please call Customer Service at 1-800-288-2792 to 

obtain a Return Authorization Number and shipping instructions. A copy of the sales receipt 

is required to validate in-warranty coverage.  

Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. 

It does not cover (i) products which have been damaged by negligence or willful actions, misuse 

or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or 

broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s 

or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service 

Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the 

product other than to the original purchaser. In no event will eKids or any of its affiliates, contractors, 

resellers, their officers, directors, 
shareholders, members or agents be liable to you or any third party for any consequential or 

incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do 

not allow limitations on implied warranties or exclusion of consequential damages, so these 

restrictions may not apply to you.) This warranty gives you specific legal rights, and you may 

also have other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above mentioned 

disclaimer of warranty is contractually binding to you upon your transfer of currency (money 

order, cashier's check, or credit card) for purchase of your eKids product.

Questions? Visit www.ekids.com 

For any other questions: 1-800-288-2792 Toll Free

© & ™ Lucasfilm Ltd. Used Under License. eKids, LLC

Li-B17-031319-C 

Printed in China

FCC ID: EMOLIB17

IC: 986B-LIB17

Model: Li-B17E7 (Front)

IB (English) 

Size: 432Wmm x 200Hmm

Color: Print  in Black color

Date: May 20,  2019

Questions? Visit www.ekids.com

Model: Li-B17E7

CHARGE

BEFORE

USE

Charging the Li-B17

•  Whenever the unit is set to Bluetooth (   ) mode, the Li-B17 will attempt to 

autolink a previously paired device for 3 minutes. If no device is paired, or to 

pair a new device, follow the steps below:

•  Make sure your Bluetooth device and the Li-B17 are fully charged. Turn on 

your Bluetooth device and turn on Bluetooth mode (check in Options or 

Settings). 

•  Slide the Try Me/OFF/     Switch on the speaker to the Bluetooth position

   (    ). Press and hold the Bluetooth Pairing Button      for 3 seconds. The blue 

LED light will flash, and a tone will sound as the speaker enters pairing mode.

•  “StarWarsLi-B17” should appear on your device. If “Not Connected” or similar 

message appears, select “StarWarsLi-B17” to connect. If your device asks for 

a passcode, enter ‘1234’.

•  Once paired, a confirmation tone will sound and the blue LED will glow solid. 

You can then stream audio to the speaker.

•  Control Bluetooth audio from your device. Remember to turn off the speaker 

and your device after listening. 

•  If no device is paired within 15 minutes, a failure tone will sound, the blue LED 

will flash slowly and the unit will revert to standby mode.  To retry pairing, press 

and hold the Bluetooth Pairing Button     for 3 seconds. If pairing is not success-

ful, turn the power “OFF” on the speaker and repeat pairing procedure.  

NOTE: To cancel current pairing mode, quickly press the 

Bluetooth Pairing

 

Button     for 1 second. 

   

   

Using Bluetooth with the Li-B17

Answer / End Calls

The Li-B17 also comes equipped with a Speakerphone function which will  be 

active when a call is coming through to your linked Bluetooth device. When an 

incoming call is received on your device, briefly press the 

Bluetooth 

Pairing/Spearkerphone/Sound Effects

 Button on the speaker once to answer 

the call. Press and hold for 2 seconds to reject the call. Speak into the microphone 

during the call. To end the call, briefly press the 

Bluetooth 

Pairing/Speakerphone/Sound Effects

 Button again.

FCC Information

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. 

This device complies with Part 15 of the FCC Rules, operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment.

•   NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

 device, 

pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•   Reorient or relocate the receiving antenna.

•   Increase the separation between the equipment and receiver.

•   Connect the equipment into an outlet on a circuit different from that to which the receiver is 

 connected.

•   Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B)

Declaration ID: D024962

IMPORTANT

Read before proceeding

If you have any question regarding the operation or use of this product, please visit 

www.ekids.com 

to view answers to frequently asked questions.

To learn more about this and other iHome products, please visit us online at 

www.ekids.com

This item is NOT a toy 

MILLENNIUM FALCON

 

SPEAKER

This device uses an internal rechargeable lithium-ion battery that should last the lifetime 

of the device. If you suspect your battery may be dead, try charging it several times. If 

the battery does not recharge, please contact us for repair information.
WARNING/DISPOSAL OF UNIT

Please do NOT attempt to change the battery yourself. If the battery has died and you do 

not want us to replace your battery, you should follow the disposal instructions below:

•   Never dispose of used batteries/electronics with ordinary solid wastes, since they 

contain toxic substances.

•   Always dispose of used batteries/electronics in accordance with the prevailing 

community regulations that apply to the disposal of batteries/electronics. If there are 

no local regulations concerning battery/electronics disposal, please dispose of the 

device in a waste bin for electronic devices.

•   Many electronics retailers now recycle batteries and other electronic components at 

no charge. Check to see which ones in your area do so.

CAUTION

The battery used in this device may present a risk of fire, explosion or chemical burn if 

mistreated

•  Never use or charge the battery if it appears to be leaking, discolored, deformed, or 

in any way abnormal.

•   Never disassemble the unit or attempt to remove battery as that could cause leakage 

of alkaline solution or other electrolytic substance.

•   Always confirm that the temperature is 5°C  35° C (41° - 95° Fahrenheit) before you 

charge the battery.

•  Leakage or deterioration of the battery may occur if this warning is not heeded.

•   Never expose the battery to any liquid.

•   Never expose the battery to excessive heat such as direct sunlight or fire.Never use 

the battery pack in an unventilated vehicle where excessive internal temperatures may 

be encountered.

•   Always keep the battery out of the reach of infants and small children.

Internal Rechargeable Lithium-ion Battery

Maintenance

•  Place the unit on a level surface away from sources of direct sunlight or excessive 

heat.

•  Protect your furniture when placing your unit on a natural wood and lacquered 

finish. A cloth or other protective material should be placed between it and the 

furniture.

•  Clean your unit with a soft cloth moistened only with mild soap and water. Stronger 

cleaning agents such as thinner or similar materials can damage the surface of 

the unit.

The Li-B17 is powered by a rechargeable battery in the speaker. 

Make sure to 

charge speaker before use, using supplied USB cable.

•  Connect the micro-USB plug to the        Audio/Charging jack on the speaker.

•  Connect the standard USB plug to a powered USB port, such as that on a 

computer. Your computer should be connected to a wall outlet when speaker 

is charging. The light on the speaker will turn to solid red while charging and 

turn off when fully charged.

•   When the battery is low, the red LED light will turn on. If you start to notice 

sound distortion at higher volumes, it's time to recharge the batteries.     

NOTE: The charging LED light will override the pairing LED light pattern.

Limited 1 Year Warranty Information

IC Statement

 

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic 

Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions: 

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the 

device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR 

d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio 

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

(1) L’appareil ne doit pas produire de brouillage;

(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible 

d’en compromettre le fonctionnement.

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.

l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.

Отзывы: