IGT Cobalt 27, Руководство по обслуживанию

Страница: 7 / 90

Safety
This section contains safety precautions that should be reviewed and followed when troubleshooting
any IGT machine. It includes safety precautions that pertain to all IGT products.
General Safety Precautions
l
Follow all applicable local electrical codes. Check to ensure that adequate power is available
based on the requirement(s) of the system being installed.
l
Always ensure that the electrical outlets are correctly wired and properly grounded. Polarity
and ground testers are available from most electronic stores. Test all outlets in the work area
before working on any electrical equipment. If there are any doubts about the wiring in the
work area, consult a qualified electrician.
Never use an adaptor plug to connect a three-prong power plug to a two-prong wall
outlet. Adaptors defeat the ground pin and eliminate the grounding protection.
l
When working with either AC or DC voltage, take care not to touch the wires or circuitry to
each other or any other point of contact, including yourself. Use only approved test
equipment that is in good working condition.
l
Turn off the power prior to connecting or disconnecting any electronic or electrical
components.
l
Take precautions to protect sensitive electronic components from damage before moving
previously installed equipment.
l
Disconnect the machine from all power sources before making changes to operating voltage
or frequency. Double check all electrical connections before applying power to avoid
permanent damage to the machine's electronic components.
l
Handle all glass with extreme care to avoid breakage or injury from potentially sharp edges.
l
Be cautious when handling all sheet metal to avoid injury due to sharp edges.
l
Verify that the machine is securely bolted to a stand before beginning any work.
l
Replace safety-critical components with the manufacturer’s recommended parts only.
l
Use caution to keep hands clear of pinch points when closing doors.
Cobalt™ 27 7