Igo ASPIRE CAMILLIEN CE, Руководство пользователя

Страница: 28 / 33

54 55
SERVICING
Servicing your bike is very important. You can avoid unnecessary
damage by servicing your bike regularly.
General maintenance
• Check tire pressure regularly
• Check brake wear every month and adjust
• Clean and Lubricate the chain occasionally
• If caught in the rain ensure bike and electrical components are
wiped dry, remove battery and allow to dry over night
• It is recommended to have your bike evaluated every 3
months by a professional bicycle technician
Before every ride
• Make sure battery is charged and locked into position
• Check tire pressure
• Check brakes for proper braking
• Always wear an approved bicycle helmet
CLEANING
Regular cleaning of your electric bike will prolong its life and
reduce the appearance of rust and corrosion build up.
REMOVE THE BATTERY BEFORE CLEANING and use brushes and wet
sponges to remove dirt. Finish by drying with paper cloths / towel.
(Use of a mild soap solution, degreaser, chain lube and a chain
cleaning device are recommended for a thorough cleaning.)
When cleaning the electric bike do not submerge parts or let water accumulate by the
battery or electrics as prolonged exposure to water may damage these components.
Note:
Do not use a hose or pressure washer to directly spray the bike. This may
result in irreparable water damage and will void your warranty.
PART SCREWS / BOLTS TORQUE VALUE
Rear derailleur mount bolt
cable screw 8 - 10 Nm
5 - 7 Nm
Gear lever mount bolt 5 Nm
Cassette lockring 40 Nm
Crank mount bolt 45 - 50 Nm
Pedal pedal axle 25 - 35 Nm
Saddle seat post with 1 fitting block
seat post with 2 fitting blocks 22 Nm
12 Nm
Seat post clamp 5 - 7 Nm
Stem faceplate
steerer 5 Nm
6 - 8 Nm
Grips clamp screw 2 - 3 Nm
Rack mount screw to the frame 5 Nm
Fender mount bolt on the fork
mount bolt on the rack/frame 5 Nm
5 Nm
Kickstand bolt 6 - 8 Nm
Brake lever handlebar mount screw 4 - 5 Nm
Disc brake rotor screw 4 Nm
Brake caliper mount bolt 5 - 7 Nm
TORQUE TABLE
The following table provides the recommended torque values for components.
Ensure all fasteners are tightened carefully and checked regularly. Use
of a torque wrench is advised to check values are correct.
Never exceed the recommended torque values.
Some components may have torque values indicated on the part.
Always respect the indicated recommended values.
iGO ASSIST