20
21
ELECTRONICS ACCESS PORT (EAP)
The Electronics Access Port gives easy access to the controller, wiring harness and sensor
array for the bicycle. It is located at the bottom bracket of the bike on the non drive side.
To access the port :
1. Loosen the 6 securing bolts located around the Access Port
cover using the correct sized Phillips head screwdriver.
2. Using a flat head screwdriver or other flat device, pry the cover off
(ensuring that you go all the way around the edge of the cover as to
not break any clamps or pins holding the cover in place).
3. Once the cover is loose, pull it towards you along the pedal shaft and
let it swing down, revealing the controller and wiring harness.
To replace the cover, simply repeat the above steps in reverse, ensuring
that you apply equal pressure around the cover to make sure it is
completely flush before tightening the securing bolts.
WEATHERPROOF CONNECTORS
Connection to the eBike peripheral components is by quick secure
weatherproof connectors. These plugs make for a secure, dry and truly
‘plug-and-play’ set-up for simple maintenance and customization.
For simplicity the following colors are used to identify the cables connecting :
red
- Brakes
orange - Throttle
green
- Display unit
When joining the weatherproof plugs take care to properly line up the pins in the connection
before applying any pressure. Turn the two connectors together to fully secure.
for : DISCOVERY ROSEMONT LE | DISCOVERY YORKVILLE LE
iGO DRIVE
IMPORTANT BATTERY SAFETY INFORMATION
DO NOT connect the positive terminal of the battery to the negative terminal.
DO NOT open your battery as it will void warranty.
The battery is sealed and therefore is rain resistant, however, DO NOT
expose your battery to repeated, continuous or excessive water flow.
Prolonged exposure to UV rays, rain and the elements may damage
the enclosure materials, store indoors when not in use.
Battery is not intended for use at elevations greater than 2000 m above sea level.
If you should encounter problems with your battery: remove the battery from
the bike and consult your authorized iGO retailer or iGO Support.
The performance of the battery will decrease at low temperatures.
Ideal operating temperature is approx. -10°C to 50°C. The guideline is that
the capacity will decrease by 1% at every 1°C of temperature drop.
DO NOT expose your battery to high temperatures (>50˚C), e.g. limit prolonged
storage in direct sunlight or in proximity to a direct heat source.
The battery is intended to be charged when the ambient temperature is between 0°C (32°F)
and 30°C (86°F). Never charge the battery when ambient temperatures are outside this range.
Make sure to only charge the battery in a dry, well ventilated area.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
Unplug the charger when the battery is fully charged, or when charger is not in use.
Use ONLY the supplied charger.
Under ideal conditions, the battery pack can be recharged approximately 750 times. The
performance will slowly decrease over time and eventually will need to be replaced.
To maintain optimal performance of Lithium-ion batteries which need to be
stored for a long time and not used, they should be kept in a state of 50%-
60% charge. They should be recharged every 3 months and recharged every
half a year. Storage should be at moderate humidity levels and between 10°-
20°C. Elevated temperatures will increase the permanent loss of capacity.
The battery should be recycled properly at the end of its life. Please recycle
your battery at an authorized recycling company in your area.
