IgniteNet SunSpot AC1200, Руководство пользователя

Страница: 45 / 67

Chapter 4
| Wireless Settings
Radio Settings
– 45 –
■
Radius Auth Secret — A shared text string used to encrypt messages
between the access point and the RADIUS server. Be sure that the same
text string is specified on the RADIUS authentication server. Do not use
blank spaces in the string. (Maximum length: 255 characters)
■
Radius Acct Server — Specifies the IP address or host name of the
RADIUS accounting server.
■
Radius Acct Port — The UDP port number used by the RADIUS server
for accounting messages. (Range: 1024-65535; Default: 1813)
■
Radius Acct Secret — A shared text string used to encrypt messages
between the access point and the RADIUS server. Be sure that the same
text string is specified on the RADIUS accounting server. Do not use
blank spaces in the string. (Maximum length: 255 characters)
■
WPA2-EAP —WPA was introduced as an interim solution for the
vulnerability of WEP pending the ratification of the IEEE 802.11i wireless
security standard. In effect, the WPA security features are a subset of the
802.11i standard. WPA2 includes the now ratified 802.11i standard, but also
offers backward compatibility with WPA. Therefore, WPA2 includes the
same 802.1X and PSK modes of operation and support for TKIP encryption.
A RADIUS server is used for authentication, and can also be used to
accounting.
Refer to WPA-PSK for a description of encryption methods.
Refer to WPA-EAP for a information on configuring the RADIUS server.
◆
Access Control List — Wireless clients can be authenticated for network access
by checking their MAC address against the local database configured on the
access point. (Default: OFF)
■
Policy — The MAC list can be configured to either allow or deny network
access to specified clients. (Default: Allow all MACs on list)
■
Filtered MACs — Enter a physical address for each client. Enter six pairs of
hexadecimal digits separated by colons, and followed by an optional
comment; for example, 00:90:D1:12:AB:89 John Smith’s PC
Network Settings
◆
Network Behavior — One of the following connection methods must be
specified. (Default: Route to Internet)
■
Bridge to Internet — Configures an interface as attached to the WAN.
Traffic from this interface is directly bridged into the Internet. (See Figure 6,
“Bridge to Internet", on page 17 .)