iglu Inuit 6I, Руководство по установке

Страница: 48 / 73

48
HOW TO CONNECT YOUR EXTENDED POWER CABLES

Prepare your tools.
Tools Specification Shape
Crimping pliers MH-14
Connection sleeve (mm) 20x6.5 (HxOD)
Insulation tape Width 19mm
Contraction tube (mm) 70x8 (LxOD)

As shown in the figure, peel off the shields from the rubber and wire of the power cable.
Peel off 20 mm of cable shields from the pre-installed tube.

For information about the power cable specifications for indoor and outdoor units, refer to the installation
manual.

After peeling off cable wires from the pre-installed tube, insert a contraction tube.

If cable wires are connected without using connecting sleeves, their contact area becomes reduced, or
corrosion develops on the outer surfaces of the wires (copper wires) over a long time. This may cause an
increase in resistance (reduction of passing current) and consequently may result in a fire.

Insert both sides of the core wire of the power cable into the connection sleeve.

Method 1: Push the core wire into the sleeve from both sides.

Method 2: Twist the wire cores together and push it into the sleeve.