Igloo BALI, Инструкция по эксплуатации

Страница: 15 / 56

en
13
User manual BALI www.igloo.pl
1.9 - mod/C 230/50 0,6 57,6 2,0 800 33 215
2.5 - mod/C 230/50 0,7 68 2,5 800 33 255
3. PREPARING THE DEVICE FOR EXPLOITATION
3.1. Requirements concerning the place of installation
• Verify whether the cross section of feeding conduits is proper for power consumption of the installed
device.
• It is forbidden to connect the device by extension rods or dividers.
• The device should be connected to the separate, properly made electric circuit with plug-in socket with
• protecting pin (according to PBUE /Regulations concerning Electric Equipment Construction/)
3.2. Connection and actuation
• Unpack the device and remove the wooden platform from the basis Fig.3 (p.4)
• The device should be placed on an even and on a sufficiently hard base, and then level it with the help of
levelling feet.
• Remove the protection foil from the elements of the device (f. ex. from the inside of the device, display she-
lves, front fender beam)
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following
operations:
1. Fix hooks in frame rails Fig.4 (p.14)
2. Place shelves and/or baskets on hooks Fig.5 (p.14) and/or Fig.7 (p.15)
3. (Concerns the devices with internal aggregate) Place the condensate container on the basis of the aggregate,
under water outflow hose (does not concern devices with automatic condensate evaporation) Fig.9 (p.17)
4. (Concerns the devices to be mounted on central aggregate) Defrosting water outflow is located under the bot-
tom of the body (about 10mm from the back of the rack, in the middle part of the body), which needs toallow
water outflow to the sewage grit.
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by
means of extension cords or dividers!)
• Turn on the main switch Fig.8/2 (p.15), which activates the thermostat, and then aggregate of the device
• Set the temperature on thermostat control panel Fig.8/1 (p.15) (thermostat service details on p.20 or 21)
• Turn on the lighting switch Fig.8/3 (p.15)
• The first cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protec-
tive layer and components of the device! Any residue of adhesives or silicone on metal elements should be re-
moved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
After installation of the device at the destination place it should be left to rest for at least 2 hours before
turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent problems
with starting up the aggregate.
WARNING: Keep out the cooling circuit from damage!