![background image](http://html1.mh-extra.com/html/igenix/ig7250/ig7250_instructions-for-use_621665004.webp)
4
Operating Instructions
Before First Use
Before using the kettle for the first time, fill with water to the MAX level, boil and pour away. Repeat
this several times using fresh water each time you boil the kettle.
Using your Kettle
•
Place the cordless base (E) on a level firm surface.
•
Where ever possible fill the kettle through the spout as this will help to reduce the amount of
limescale that builds up on the filter.
•
The amount of water can be measured by the level mark (D) on the outside of the kettle. Never fill
the kettle above the MAX level and ensure it is always above the MIN level.
•
Only fill the kettle with the amount of water you need as this will save electricity.
•
Always make sure that the lid is properly firmly closed.
•
Place the kettle on the cordless base (E) making sure it is positioned correctly.
•
Plug in and switch on at the wall socket.
•
Put the ON / OFF switch (F) to its ‘ON’ position and the switch will illuminate.
•
When the water boils the kettle will switch off automatically. The kettle can be switched off
manually by putting the switch (F) to the ‘OFF’ position.
•
To re-boil the kettle, switch on again. If the appliance has just switched off, wait a minute or so
before switching back on.
•
When the kettle has boiled the water may be poured out through the spout.
•
This kettle is fitted with a safety cut-out to protect the kettle from damage in case of inappropriate
use.
•
Should the kettle be accidently operated without water or if all of the water has evaporated, the
safety cut-out will automatically switch off the heating element.
•
In such a case, remove the plug from the wall socket immediately and refill the kettle. Allow the
element to cool for a few minutes and then start using the kettle as normal.
Descaling
IMPORTANT: As this kettle is fitted with an immersed element it must be regularly descaled. The
frequency of descaling depends on usage and the hardness of the water in your area.
Excessive amounts of scale can cause the kettle to switch off before reaching boiling point and cause
damage to the element which is not covered by the guarantee.
•
Any regular descaling agent may be used, provided the relevant instructions are observed.
•
Do not fill the kettle to the upper mark to avoid spillage if the descaling agent causes the water to
foam.
•
To clean the kettle thoroughly of any decalcification residues, let it go through several boiling
cycles using clean water with each cycle. Rinse the kettle with clean water afterwards.
Cleaning and Care
•
Before cleaning the kettle, ensure it is disconnected from the power supply and has cooled down
completely.
•
Do not use abrasives or harsh cleaning solutions.
•
Do not immerse the base or the kettle in any liquid. To clean the exterior, use a slightly damp lint
free cloth.
•
It is advisable to remove limescale deposits at regular intervals.
Troubleshooting
Problem
Possible Cause
Solution
The kettle does not work.
1. Not properly plugged into the
mains wall socket.
2. No electricity in the mains
wall socket.
3. On/Off switch not turned on.
4. Safety cut-out activated.
1. Plug in firmly
2. Check fuse or breaker.
3. Push on/off switch to on.
4. Fill the kettle and allow to
cool for a few minutes.
The kettle cuts out before it
boils.
1. Large build up of scale in the
kettle.
1. Use a descaling agent to
clean the kettle.
Kettle scales up quickly.
1. You live in a hard water area.
1. Regularly de-scale your kettle