IFM SmartPLC DataLine AC1423, Руководство по эксплуатации устройства

Страница: 111 / 200

SmartPLC DataLine with EtherNet/IP device interface
111
>
6.6 Set Ethernet configuration interfaces
42937
To configure the Ethernet configuration interfaces 1 (X3) and 2 (X8):

Ethernet configuration interface 1 (X3):
► >
►
Select [IP setup].
►
Set interface parameters (→ Notes on IP settings (→ S. 83 )).

Ethernet configuration interface 2 (X8):
►
>
►
Select [IP setup].
► Set interface parameters (→ Notes on IP settings (→ S. 83 )).
>
6.7 Exchange AS-i slave
41506
AC1423/24 makes it possible to replace an AS-i slave by a new AS-i slave in the operating mode
"protected mode".
Requirements:
> The new and the old AS-i slave have the same device profile(→ Profiles of AS-i slaves (→ S. 129 )).
> The new AS-i slave has the address
0
.
> Parameter [Automat. adressing] is activated (→ Set the monitoring functions of the AS-i master (→ S. 51 )).
1 Remove old AS-i slave
►
Disconnect the AS-i slave to be replaced from the AS-i network
> AC1423/24 detects a configuration error and generates a corresponding OSC message.
2 Install new AS-i slave
►
Connect the new AS-i slave to the AS-i network.
> AC1423/24 detects the new AS-i slave and automatically assigns the address of the old AS-i slave.
> The OSC error message disappears.
> The new AS-i slave is operational.