Multicode Reader
O2I5xx
19
8 Operating and display elements
3
4
5
6
2
7
1
Fig. 11: LEDs and button
1: teach LED (green)
2: teach LED (yellow)
3: Ethernet LED (green)
4: power LED (green)
5: OUT1 LED (yellow)
6: OUT2 LED (yellow)
7: teach button
8
Fig. 12: Laser markings
8: red laser laser markings (655 nm)
8.1 Signal indications
Green teach LED
Yellow teach LED
Laser markings
Description
on
---
on
Alignment mode active
on
flashes at 1 Hz
flash at 1 Hz
Set-up mode active
flashes at 2 Hz
---
---
Configuration is saved
on for 2 s
---
---
Configuration successfully saved
flashes at 8 Hz
flashes at 8 Hz
---
Active mode for configuration transfer from
ifm storage device via teach button
---
flashes at 8 Hz
---
Error: lock button is active
---
flashes at 8 Hz
flash at 8 Hz
Error: configuration failed
Tab. 2: Teach LEDs (green, yellow), laser markings
Ethernet LED
Power LED
OUT1 LED
OUT2 LED
Description
---
on
---
---
Unit is ready for operation.
---
flashes at 0.5 Hz
---
---
No parameters set or parameter
setting was not loaded into the
unit.
On
Off
---
flashes 2x at 0.5 Hz
---
---
Unit is in parameter setting mode.
On
Off
---
on
on
---
OUT1 is switched.
---
on
flashes at 8 Hz
---
OUT1 has a short circuit.
---
on
---
on
OUT2 is switched.
---
on
---
flashes at 8 Hz
OUT2 has a short circuit.
on
on
---
---
Unit is ready for operation, Ether-
net is connected.
flashes
on
---
---
Ethernet transmitting data.
Off
---
---
---
Ethernet not connected.
---
---
flashes at 8 Hz
flashes at 8 Hz
Unit signals internal error.
