IFM Ecomat 300 AC1421, Руководство по эксплуатации устройства

Страница: 163 / 365

163
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Appendix Fieldbus EtherNet/IP
>
Parameter setting via the configuration assembly object
Device-specific parameters ..................................................................................................................164
Parameters of the fieldbus slots ...........................................................................................................174
Derivation of parameter values for free slave assignment ...................................................................180
12810
In
→ Configuration mode: Top-down
(
→ page
336 ), the parameter data are set in the EtherNet/IP
projection software (
→ Configuration mode: Top-down
(
→ page
336 )). By means of the configuration
assembly object, the configuration is then transferred to the device and activated.
Only when a connection is established by the I/O scanner will the parameter data configured
via the configuration assembly object be transferred to the device. Changes to the parameter
data in the online mode of the controller will therefore only become effective after the next
connection.
To trigger a new connection setup, perform one of the following actions:

Reboot the device

Perform a system reset (
→
System reset
(
→ page
86 ))

Briefly interrupt the EtherNet/IP connection between the I/O scanner and the device

Transfer the project from the higher-level controller to the device (download)

Restart the I/O scanner
The configuration in top-down mode includes the following parameters:

Parameters of the fieldbus slots
(
→ page
174 )

Device-specific parameters
(
→ page
164 )