IFM Ecomat 300 AC1375, Руководство по эксплуатации устройства

Страница: 172 / 523

ifm Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376) 2012-02-23
DP module 7 – command channel Commands in DP module 7
172
10 DP module 7 – command channel
Commands in DP module 7 ...................................................................................................... 172
5603

Table Overview of the commands in the DP module 7 ( → page 164 )
10.1 Commands in DP module 7
Module 7, command 01 – Read master flags ........................................................................... 173
Module 7, command 02 – Change operating mode.................................................................. 174
Module 7, command 03 – Read current slave configuration .................................................... 175
Module 7, command 04 – Read projected slave configuration................................................. 177
Module 7, command 05 – Change projected slave configuration............................................. 179
Module 7, command 06 – Read slave parameters ................................................................... 181
Module 7, command 07 – Change projected slave parameters ............................................... 182
Module 7, command 08 – Read LAS (list of active slaves) ...................................................... 184
Module 7, command 09 – Read LDS (list of detected slaves).................................................. 186
Module 7, Command 10 (0Ahex) – Read LPF (list of slaves with peripheral fault) .................. 188
Module 7, command 11 (0Bhex) – Read LPS (list of projected slaves) ................................... 190
Module 7, command 13 (0Dhex) – Read telegram error counter ............................................. 192
Module 7, command 14 (0Ehex) – Read configuration error counter....................................... 194
Module 7, command 15 (0Fhex) – Read AS-i cycle counter .................................................... 195
Module 7, command 16 (10hex) – Change current slave parameters...................................... 196
Module 7, command 19 (13hex) – Project all ........................................................................... 198
Module 7, command 21 (15hex) – Save configuration in flash memory................................... 199
Module 7, command 22 (16hex) – Reset telegram error counter of a slave............................. 200
Module 7, command 23 (17hex) – Address slave..................................................................... 202
Module 7, command 62 (3Ehex) – [Continuous Command] operating mode........................... 204
Module 7, command 63 (3Fhex) – No-operation command without function ........................... 206
5607