Speed monitor
DP2122
27
9 Parameter setting
During parameter setting the unit remains in the operating mode. It continues its monitoring
functions with the existing parameters until the parameter setting has been completed.
9.1 Parameter setting in general
Each parameter setting consists of 6 steps:
Step
Button
1
Change from operating mode to parameter setting mode.
[●]
2
Select the requested parameter [SP1], [C.FEP], etc.
[▲] or [▼]
3
Change to the programming mode of the parameter.
[●]
4
Select or change the parameter value.
[▲] or [▼] > 2 s
5
Acknowledge the set parameter value.
[●]
6
Return to the operating mode.
[esc]
9.1.1 Example [ModE] - switch point mode for OUT2
Step
Display
1
Change from operating mode to parameter setting mode.
u
Press [●] to get to the menu.
w
The first parameter is displayed.
2
Select the requested parameter, here [SSC2].
u
Press [▼] until [SSC2] is displayed.
u
Press [●] to get to the extended functions menu.
w
The first parameter of the extended functions is displayed.
3
Change to the programming mode of the parameter.
u
Press [●] to change to the programming mode.
w
The currently set parameter value is displayed.
4
Select or change the parameter value, here e.g. [und].
u
Press [▼] or [▲] for at least 2 s.
w
The currently set parameter value flashes, here e.g. [1-P].
w
After 2 s:
- value is changed continuously by keeping the button pressed.
- value is changed incrementally by pressing the button once.
Numerical values (→ 9.2.3)
5
Acknowledge the set parameter value.
u
Briefly press [●].
w
The parameter is displayed again.
w
The new setting value is saved.
Setting of other parameters:
u
Press [▼] or [▲] until the requested parameter is displayed.
6
Return to the operating mode.
u
Press [esc].
u
- Press [▼] or [▲] several times until the current measured value is displayed.
- Or wait for the timeout function (approx. 30 s).
w
The unit has returned to the operating mode.
w
The current value is displayed.
GB
