SafetyController CR7032
6
Remove and cover the plus and minus terminals of the batteries�
Disconnect all contacts of the controller from the on-board system prior to welding
on the vehicle or plant� Connect the earth terminal of the welding device directly to
the part to be welded�
Do not touch the controller or electric cables with the welding electrode or the
earth terminal of the welding device�
Protect the controller against weld slag�
3 Functions and features
The freely programmable controllers of the "SafetyController" series are rated for
use under difficult conditions (e�g� extended temperature range, strong vibration,
intensive EMC interference)�
►
Observe the operating conditions
(→ 7.2 Test standards and regulations)
WARNING
Observe the introduction (→ pages II ff)!
●
Functions and features
●
Programming and important additions to these instructions
●
Set-up
