IFM AL4042, Руководство по эксплуатации

Страница: 32 / 58

AL4042 Remote I/O module 16 DI
32
Name Description Value range Access
[configuration] > [connection-
timeout] Set timeout for interruption of the fieldbus
connection (value in milliseconds) • 20: 2 ms
…
• 31000: 31000 ms
…
• 60000: 60000 ms
rw
1
[configuration] > [byteswap] Arrangement of the bytes in a data word • big-endian: Big-endian format
• little-endian: Little-endian
format
rw 1
1
read and write
2
read only
Requirements:
ü
IoT Core Visualizer has been launched.
ü
The [Parameter] menu is active.
u Select the [Fieldbussetup] submenu.
w The menu page shows the current settings.
u Set the parameters.
u
Click on

to save the changes to the device.
u
If necessary, restart the device.
w The ModbusTCP interface is configured.
9.2.3.2 Configuring input filters
u
Observe the notes on input filters: Digital input filters (
Ò /
8)
Available parameters:
Name Description Value range Access
[pin2] > [debounce_time] Pin 2: debounce time (= value * 0.1 milisec-
onds) • 0: 0 ms (default)
…
• 500: 50 ms
rw
1
[pin2] > [hold_time] Pin 2: Hold time (= value * 0.1 milliseconds) • 0: 0 ms (default)
…
• 60000: 6000 ms
rw
1
[pin2] > [hold_level] Pin 2: Hold level • low: hold LOW
• high: hold HIGH (default)
rw 1
[pin2] > [invert] Pin 2: Inversion • signal not inverted: do not invert
(default)
• signal inverted: invert
rw
1
[pin4] > [debounce_time] Pin 4: debounce time (= value * 0.1 milisec-
onds) • 0: 0 ms (default)
…
• 500: 50 ms
rw
1
[pin4] > [hold_time] Pin 4: Hold time (= value * 0.1 milliseconds) • 0: 0 ms (default)
…
• 60000: 6000 ms
rw
1
[pin4] > [hold_level] Pin 4: Hold level • low: hold LOW
• high: hold HIGH (default)
rw
1
[pin4] > [invert] Pin 4: Inversion • signal not inverted: do not invert
(default)
• signal inverted: invert
rw
1
1 The parameter can only be changed if no connection to the fieldbus controller is active