IFM AC1403, Руководство по эксплуатации устройства

Страница: 40 / 174

SmartPLC DataLine with Profinet device interface
40
>
5.3.2 Quick setup: Configure the operating mode of the AS-i masters
41778
Information regarding the operating modes of an AS-i master:
→ Operating modes of the AS-i
master
(
→ S.
118 )
To configure the operating modes of the AS-i masters:
1 Select the menu page
►
► Select [Operation modes] tab.
2 Configure the operating mode of AS-i master 1 and the behaviour of the connected AS-i slaves
> In group [AS-i master 1], set the following parameters as required:
Parameter Description Possible values
[Projection mode] Active operating mode of the
AS-i master Projection mode inactive:
AS-i network runs in protected mode (normal mode)
Projection mode active:
AS-i network can be projected.
(
→
Quick setup: Address the AS-i slaves connected to AS-i
Master 1
(
→ S.
45 ) or
→
Quick setup: Address the AS-i slaves
connected to AS-i Master 2
(
→ S.
46 ))
[No slave reset] Behaviour of the AS-i slaves
when changing the operating
mode Slave is reset when changing the operating mode:
When changing the operating mode, the AS-i slaves will
be reset for a short moment (reset or offline phase).
Slave is not reset when changing the operating mode:
When changing the operating mode, the AS-i slaves
continue to operate without interruption.
> Selected values are applied.
3 Optional: set the operating mode of AS-i master 2 and the behaviour of the AS-i slaves
► Repeat step 2 for the group [AS-i master 2].