11
UK
8 Addressing
The safe AS-i output module can be addressed, when mounted and wired, via the
addressing unit AC1144 with the cable (EVC076); the address is set to 0 at the
factory�
A special feature of the safe AS-i output module are the two types of AS-i
addresses:
the safe AS-i address
•
detects the communication on the safe address of the
safety monitor and switches on the basis of the detected data�
the non safety-related AS-i address
•
serves for diagnosis and switching under
normal operating conditions�
On delivery, all safe output modules with the same safe AS-i address switch in
parallel� This can be changed by means of the parameter bits�
9 Programming
Programming of the safety-related AS-i address
Set the switch on the unit to P (programming) (running light of the inputs I1-
1�
I3/1�Y1)�
Set the desired address with the addressing unit or the AS-i master�
2�
Check the programmed address with the addressing unit or the AS-i master�
3�
Check the ID code of the slave with the addressing unit or the AS-i master� The
4�
code should be "F"�
Check the ID1 code of the slave with the addressing unit or the AS-i master�
5�
The code should correspond to the tens digit of the address�
Check the ID2 code of the slave with the addressing unit or the AS-i master�
6�
The code should correspond to the units digit of the address�
Check the IO code of the slave with the addressing unit or the AS-i master� The
7�
code should be "7"�
When all steps from 3 to 7 have been carried out correctly, you can proceed
8�
with step 9� Otherwise, repeat from step 1�
Set the switch of the unit to R (RUN)�
9�
