IFC IFC-BOX4000, Руководство пользователя

Страница: 15 / 47

IFC-BOX4000 User Manual ver 2.0
8
2.1 Jumpers
2.1.1 Jumper Description
Board can be configured by setting jumpers. A jumper is a metal bridge used to close an
electric circuit. It consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To close a jumper, you connect
the pins with the clip. To open a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1 and 2, or
2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have any
doubts about the best hardware configuration for your application, contact your local
distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
Warning! To avoid damaging the computer, always turn off the power
supply before setting jumpers.
How to verify Pin1 of the jumper?
1. Please check the M/B carefully, where there is a mark of “1” or white thick line, there is
Pin1.
2. Look into the pad on the back side of the M/B, generally the square side of the pad is
Pin1.