background image

 

IER 400 

N0C4SEA2 

 

USER SAFETY GUIDE 

WARNING 

THIS PRODUCT COMES WITH A LITHIUM BATTERY. BATTERY REPLACEMENT MUST IMPERATIVELY 
BE PERFORMED BY QUALIFIED MAINTENANCE PERSONNEL. MOREOVER, ONLY IER APPROVED 
MODELS MAY BE USED. 

DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE 
SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISPOSE OF USED 
BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS. 

DO NOT OPEN THE POWER SUPPLY UNIT CASE FOR ANY REASON, SINCE HIGH VOLTAGE MAY BE 
PRESENT. 
DO NOT REPLACE THE FUSE OF THE POWER SUPPLY UNIT. 

The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following 
notice be brought to the attention of users of this product. 
NOTE :  This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 

-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
-  Consult the dealer or an experienced radio/TV technician for help. 

In accordance with FCC requirements, changes or modifications not expressly approved by IER 
could void the user's authority to operate this product. 
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules. 

NORWAY:  This product is also designed for IT power distribution system with phase-to-phase 
 voltage 

230V. 

NORWAY & SWEDEN: Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk. 

THIS APPLIANCE MUST BE GROUNDED. 

THIS PRODUCT MUST EXCLUSIVELY BE CONNECTED TO AN ELECTRICAL CIRCUIT THAT IS 
-  PROVIDED WITH A GROUND FAULT CIRCUIT INTERRUPTER (GFCI) COMPLYING WITH 

IEC 364 AND NFC15-100 REGULATIONS, AND 

-  CONFORMING WITH THE VOLTAGE CHARACTERISTICS SPECIFIED BY THE NF EN 50160 STANDARD. 

The cover(s), and/or door(s) of this product is (are) intended for occasional use and must be normally closed. 

 

 

In compliance with the European Directive 2002/96/CE relative to the management of Waste Electrical and 
Electronic Equipment (WEEE) implemented as of August 13, 2005, this product may not be disposed of with 
regular household waste. All products concerned by this directive are marked with the above symbol.  
The end owner of this product is responsible for either: 

•  Transferring the product to an authorized treatment facility  where the product components,  recognized to 

present a hazard to the environment and/or public health,  will be recycled and recovered properly, or 

•  Consulting with the manufacturer for appropriate product waste management according to the terms of the 

manufacturer. 

 

The information and specifications contained in this document are subject to change without prior notice. 

ENGLISH 

Содержание 400

Страница 1: ...ver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help In accordance with FCC requirements changes or modifications not expressly approved by IER could void the user s authority to operate this product Use of a shielded cable is required to comply within Class B limits of Part 15...

Страница 2: ... POWER UP Connecting to the Line Voltage Connect the AC power cord first to the AC power connector on the IER product see illustration opposite and then to the AC power outlet Powering Up Set the power switch to the I position see illustration opposite POWERING DOWN MAKING THE IER PRODUCT ELECTRICALLY SAFE Powering Down Set the power switch to the 0 position see illustration opposite Making the IE...

Страница 3: ...nce entre le matériel et le récepteur brancher le matériel sur un autre circuit que celui du récepteur consulter le revendeur ou un technicien de radio télévision expérimenté Conformément aux exigences de la FCC toutes modifications apportées au produit non expressément approuvées par IER pourrait entraîner l interdiction pour l utilisateur d exploiter ce produit L utilisation d un câble de transm...

Страница 4: ...accordement à l alimentation secteur Brancher le cordon secteur au connecteur d alimentation du terminal voir illustration ci contre puis à la prise d alimentation secteur Mise sous tension Appuyer sur l interrupteur en position I voir illustration ci contre EXTINCTION MISE EN SÉCURITÉ Extinction Appuyer sur l interrupteur en position 0 voir illustration ci contre Mise en sécurité Débrancher le co...

Отзывы: