Transferring readings via Bluetooth®
28
7
Transferring readings via Bluetooth
®
If the blood pressure monitor is configured to transfer
readings via Bluetooth
®
, readings will be sent to the
database automatically.
All readings which have not yet been sent to the
database will be sent together.
The blood pressure monitor will emit a short beep after
transferring readings to confirm that the readings have
been transferred successfully.
Note
▪
In the event of problems with data transfer,
please see section 12 Error messages. If
problems persist, please contact your
healthcare provider.
▪
In the event of problems with data transfer,
if there are more than 15 readings, any new
readings will overwrite the oldest readings.
7.1
Active pairing (Bluetooth modem)
Note
Pairing requires some basic familiarity with
Bluetooth. If you are not familiar with Bluetooth,
please contact your healthcare provider.
The Bluetooth connection is preconfigured, but in the
event of certain rare faults you may need to create a
Bluetooth connection manually.
To do this:
1)
Activate Bluetooth on the data transfer device
(e.g. mobile phone, tablet, Bluetooth modem).
Note
Please consult the operating instructions for your
device.
The blood pressure monitor should be no more
than 10 m from the device, otherwise it may not
be possible to establish a data connection.
Содержание Tel-O-Graph BT plus
Страница 1: ...Operating manual EN Tel O Graph BT plus ...
Страница 51: ...Rev A 18 12 2018 ...