IEI Technology NANO-QM770, Руководство пользователя

Страница: 60 / 191

NANO-QM770 EPIC SBC
Page 44
Figure 4-2: PCIe Mini Card Installation
Step 1: Insert into the socket at an angle . Line up the notch on the card with the notch
on the connector. Slide the PCIe Mini card into the socket at an angle of about
20º.
Step 2: Push down until the card clips into place . Push the other end of the card
down until it clips into place on the plastic connector. Step 0:
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.