IEI Technology NANO-ADL-P, Руководство пользователя, Страница: 67 / 149

NANO-ADL-P
Page 67
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the components and injury to the
user.
Before and during the installation please DO the following:
▪ Read the user manual:
o
The user manual provides a complete description of the NANO-ADL-P
installation instructions and configuration options.
▪ Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD
cuff removes ESD from the body and helps prevent ESD damage.
▪ Place the NANO-ADL-P on an anti-static pad:
o
When installing or configuring the motherboard, place it on an anti-static
pad. This helps to prevent potential ESD damage.
▪ Turn all power to the NANO-ADL-P off:
o
When working with the NANO-ADL-P, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the
system.
Before and during the installation of the NANO-ADL-P, DO NOT:
▪ Remove any of the stickers on the PCB board. These stickers are required
for warranty validation.
▪ Use the product before verifying all the cables and power connectors are
properly connected.
▪ Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
M.2 Module Installation
The NANO-ADL-P provide two ways to install the M.2 expansion card. One is using screw,
and the other is using the retainer. Please follow the steps below.