IEI Technology KINO-PV-D4252, Руководство пользователя

Страница: 66 / 129

KINO-PV-D5252/D4252 Mini ITX SBC
Page 53
Figure 4-4: AT/ATX Power Select Jumper Location
4.6.2 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header, p=2 mm
Jumper Settings: See
5
Table 4-3
Jumper Location: See
5
Figure 4-5
If the KINO-PV-D5252/D4252 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ
Enter the correct CMOS setting
ƒ
Load Optimal Defaults
ƒ
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
5
Table 4-3 .