IEI Technology IRS-100-ULT3, Руководство пользователя

Страница: 27 / 108

IRS-100-ULT3 Railway Surveillance System
Page 14
ƒ
Air Circulation
: Make sure there is sufficient air circulation when installing the
IRS-100-ULT3. The IRS-100-ULT3’s cooling vents must not be obstructed by
any objects. Blocking the vents can cause overheating of the IRS-100-ULT3.
Leave at least 5 cm of clearance around the IRS-100-ULT3 to prevent
overheating.
ƒ
Grounding
: The IRS-100-ULT3 should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the IRS-100-ULT3.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Unpack the system
Step 2:
Configure the system settings
Step 3:
Install the HDD/SSD, SIM card and CFast card (optional)
Step 4:
Mount the system
Step 5:
Connect peripheral devices
Step 6:
Power up the system
Step 0:
3.4 Opening the Bottom Cover
To access the main board, the bottom cover must be opened. Please follow the steps
below to open the bottom cover.
Step 1:
Turn the IRS-100-ULT3 over.
Step 2:
Remove the bottom cover retention screws (
Figure 3-1
). The bottom cover is
secured to the chassis with twelve retention screws (four on the rear panel).