IEI Technology IOWA-8522, Руководство пользователя

Страница: 107 / 244

IOWA-8522 Motherboard
Page 87
Description Label Type
Clear CMOS J_CMOS1 3-pin header
COM2 type selection JP1 6-pin header
LVDS voltage selector J_VLVDS1 3-pin header
LVDS screen resolution selector JP3 8-pin header
Table 5-1: Jumpers
5.4.1 Clear CMOS
Jumper Label:
J_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See Table 5-2
Jumper Location:
See Figure 5-10
If the IOWA-8522 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-2 .