IEI Technology IDS-310AI, Руководство пользователя

Страница: 26 / 109

IDS-310AI Embedded System
Page 12

Air Circulation : Make sure there is sufficient air circulation when installing
the IDS-310AI. The IDS-310AI must not be obstructed by any objects. Leave
at least 5 cm of clearance around the IDS-310AI to prevent overheating.

Grounding : The IDS-310AI should be properly grounded. The voltage feeds
must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the IDS-310AI.
3.2.1 High Surface Temperature
WARNING:
Some surfaces of the equipment may become hot during operation.
The surface temperature may be up to several tens of degrees hotter
than the ambient temperature. Under these circumstances, the
equipment needs to be protected against accidental contact.
The equipment is intended for installation in a RESTRICTED ACCESS LOCATION.

Access can only be gained by SERVICE PERSONS or by USERS who have
been instructed about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.

Access is through the use of a TOOL or lock and key, or other means of
security, and is controlled by the authority responsible for the location.
3.3 Bottom Surface Removal
Before internal devices can be installed, the bottom surface must be removed. To remove
the bottom surface, please follow the steps below:
Step 1: Remove the bottom surface retention screws. The bottom surface is secured to
the chassis with four (4) retention screws ( Figure 3-1 ). All four (4) screws must
be removed.