2
Configuring Your eMerge Enterprise
Connecting Power and the Network to the eMerge Enterprise
1. Connect a grounded power cord to the power connector on the back of the eMerge
Enterprise or Enterprise Ultra. See the images below.
Connecting Power and the Network
2. Connect the network cable to the network connector on the back of the eMerge Enterprise or
Enterprise Ultra. Be sure the place the cable in the correct connector as shown below.
I
0
Fan
Power connector
100-240 VAC
This connector
not currently used
Network
connector
NOTE
: The remaining USB, serial, and device connectors
are not generally used in NetBox applications.
The back panel of the Enterprise, 1U rack mount.
Fan
Power connector
100-240 VAC
This connector
not currently used
Network
connector
NOTE
: The remaining USB, serial, and device connectors
are not generally used in NetBox applications.
Monitor
Keyboard
The back panel of the Enterprise Ultra, 2U rack mount.
3. For the Enterprise Ultra (2U), open the drive door on the front panel and press the power
switch. See diagram below.
System
Reset
Alarm
Reset
Power
Inside the drive door on the Enterprise Ultra