IEI Technology ECK-3692, Руководство пользователя

Страница: 82 / 170

ECK-3692G Embedded System
Page 66
Remote Access [Disabled]
Use the
Remote Access
option to enable or disable access to the remote functionalities
of the system.
Disabled D
EFAULT
Remote access is disabled.
Enabled
Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
Serial Port Number [COM1]
Use the
Serial Port Number
option allows to select the serial port used for remote
access.
COM1 D
EFAULT
System is remotely accessed through COM1
NOTE
: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h, 4]
The
Base Address, IRQ
option cannot be configured and only shows the interrupt
address of the serial port listed above.
Serial Port Mode [115200 8,n,1]
Use the
Serial Port Mode
option to select baud rate through which the console redirection
is made. The following configuration options are available