IEI Technology DRPC-242-ADL-P Series, Руководство пользователя

Страница: 35 / 167

DRPC-242-ADL-P
Page 19
Figure 3-2: Removing the HDD Bracket
3.4 Memory Installation
The DRPC-242-ADL-P Series is pre-installed with an 8GB memory module. Users can
add or replace memory with different capacity by themselves, the installation procedures
are described below.
Step 1:
Open the two handles of the memory slot.
Step 2:
Remove the old memory module and insert a new memory module. Carefully
align the memory module so the notch on the memory lines up with the notch
on the memory socket.
Step 3:
Once aligned, press down until the memory module is properly seated and the
two handles fully clip into place (Figure 3-3).