IEI Technology DRPC-120-BT, Руководство пользователя

Страница: 51 / 121

DRPC-120-BTi Embedded System
Page 39
4.3 SO-DIMM Replacement
To install/replace the SO-DIMM modules, please follow the steps below.
Step 1:
Remove the internal access panel from the DRPC-120-BTi. Please follow the
instruction described in
Section 3.2
.
Step 2:
Locate the SO-DIMM module on the motherboard.
Figure 4-1: SO-DIMM Module Location
Step 3:
Release the SO-DIMM module by pulling both the spring retainer clips outward
from the socket.
Step 4:
Grasp the SO-DIMM module by the edges and carefully pull it out of the socket.
Step 5:
Install the new SO-DIMM module by pushing it into the socket at an angle
(
Figure 4-2
).
Step 6:
Gently push the rear of the SO-DIMM module down (
Figure 4-2
). The spring
retainer clips clip into place and secure the SO-DIMM module in the socket.