IEI Technology AFL-W15A-GM45, Руководство пользователя

Страница: 27 / 148

AFL-W15A/17D-GM45 Panel PC
Page 16
2.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to close an electrical circuit. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To
CLOSE/SHORT a jumper means connecting the pins of the jumper
with the plastic clip and to OPEN a jumper means removing the plastic
clip from a jumper.
The motherboard jumpers are listed below.
ƒ
COM1 pin 9 setup
ƒ
COM3 pin 9 setup
ƒ
COM3 RS-232/422/485 selection
2.5.1 COM1 Pin-9 Setup
Jumper Label: JP11
Jumper Type:
10-pin header
Jumper Settings:
See
5
Table 2-2
The pin-9 signal can be selected as 12 V, 5 V or Ring.
Pin Description
1-3 12 V
3-5 5 V
7-9 RI
Table 2-2: COM1 Pin-9 Setup
The pinouts for the COM1 connector are shown below.