IEI Technology AFL-***-9103, Руководство пользователя, Страница: 67 / 203

AFL-xxx-9103 Panel PC
Page 49
Step 4: Attach the hard drive bracket to the hard drive. To do this, align the four retention
screw holes in the both sides of the hard drive bracket with the retention screw
holes on the sides of the hard drive. Insert four retention screws into the hard
drive bracket ( Figure 3-6 ).
Figure 3-6: AFL-xxx-9103 Hard Drive Retention Screws
Step 5: Connect the SATA/IDE cable to the rear of hard drive.
Step 6: Install the hard drive into the panel PC by aligning the retention screw holes in
the hard drive brackets with the retention screw holes on the chassis. Insert the
four retention screws.
Step 7: Replace the aluminum back cover to the chassis.
Step 8: Replace the plastic back cover. Step 0:
3.7 AT/ATX Mode Selection
AT and ATX power modes can both be used on the AFL-xxx-9103. The selection is made
through an AT/ATX switch on the aluminum chassis inside the plastic back cover
(Figure 3-7). To select AT mode or ATX mode, follow the steps below.
Step 1: Remove the plastic back cover. See Section 3.5 above.
Step 2: Locate the AT/ATX switch on the aluminum chassis ( Figure 3-7 ).